Dual XS10 Service Manual download pdf (Page 14)

2 Description

Connection XS 8 I/O Port

Connection option for additional peripheral units.

One input and one output for each channel, additionally two high-speed outputs, see

section 7.2.5 "XS 8 I/O Port".

Connection XS 5 RS232

Serial interface for connection of a programmable logic controller (PLC) or a PC for

data readout or for firmware updating.

Connect via 9 pin Sub D cable (1:1). Only pins 2, 3 and 5 must be assigned. Observe

the serial interface protocol.

9600 baud/1stop bit/no parity/8 data bits.

Connection XS 3 Dispense monitor

Connector for a Pre-Amplifier 97211, for flow monitoring on channel A. A second

pre-amplifier for channel B can be connected with splitter cable 97529.

Calorimetric dispense monitoring requires only one Pre-Amplifier 97512. Unlike

pressure based monitoring systems, this pre-amplifier can be used for monitoring

2 dispense valves.

Connection XS 10 PLC

Parallel interface for connection of a programmable logic controller.

Per dispense channel, two output signals each are available for “Ready” and “Error”,

and two input signals for “Start” and “Reset”; additional signals for “Refill” and

“Empty” provided from product supply (reservoir).

Connection XS 2 Product reservoir

Is used to connect the product reservoir. Only one reservoir can be actuated.

XS16

XS18

XS17

XS5 RS 232

XS8 I/O Port

XS3 Flow

Monito

XS2 Reservoir

XS1 Start

XS10 PLC

Inte

rface

XS12 Valves

XS11 DC Drive

Henkel AG

& Co. KGaA

Standort München

Gutenbergstr. 3

D-85748 Garching

100-240 VA

C, 50/60

Fuse: 2A T (time-lag)

Power Consumption: 100 W

Made in G

rmany

Place for S

erial No. Sticker

2324

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 47 48

Comments to this Manuals

No comments

Dual XS10 Service Manual Page 14

Comments to this Manuals

Related products and manuals for Subwoofers Dual XS10