Dual XDVD8281 Owner's Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
5
XDVD8281 INSTALLATION
Please read entire manual before installation.
Before You Start
Disconnect negative battery terminal. Consult a qualified technician for instructions.
Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it
would be subject to dust, dirt or excessive vibration.
Getting Started
Insert the supplied keys between the radio and the sleeve at the left and right sides, and slide the unit out of the
mounting sleeve.
Mounting Options
1. Rear ISO-DIN (using OEM factory radio mounting brackets):
Remove factory radio mounting brackets and attach to the left and right sides of the XDVD8281 chassis.
See diagram below.
2. Front load (using mounting sleeve):
Install mounting sleeve into opening, bending tabs to secure.
Connect wiring harness and antenna as shown on page 6. Consult a qualified technician if you are unsure.
Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).
Test for correct operation and mount according your application.
If required, snap desired trim ring into place.
Mount the iplug™ adapter to any smooth clean surface using the supplied double-sided tape or Phillips head
screws.
Preparation
Mounting the XDVD8281 using OEM factory
mounting brackets.
Mounting the XDVD8281 using mounting
sleeve (front load).
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 59 60

Comments to this Manuals

No comments