Dual XDVD3201 Owner's Manual download pdf (Page 27)

DVD Setup - Parking Brake Initialization

Watching Video

Parking Brake Initialization

SAFETY WARNING

• The video display of the in-dash unit will not operate while the vehicle is

moving. This is a safety feature to prevent driver distraction. In-dash video

functions will only operate when vehicle is in Park and the PARKING BRAKE

is engaged. It is illegal in most states for the driver to view video while the

vehicle is in motion. Refer to local laws in your area.

• The vehicle must be in park and the parking brake applied to view video on the

in-dash monitor.

• As a safety feature, !!Safety Warning!! blue screen will show on the display

when the vehicle's parking brake is not engaged. Video display on the in-dash

monitor isn't allowed until the PARKING BRAKE is engaged. Connect the

yellow/blue PARKING BRAKE wire to the brake switch circuit as described

on page 6. Note: DVD and AUX AV audio can be heard while the vehicle is in

motion without engaging the parking brake.

Follow these two initialization procedures carefully to allow video playback on

the XDVD3201 in-dash monitor:

There are two ways to initiate the PARKING BRAKE sequence.

If vehicle is moving:

1) Stop vehicle, put in Park, make sure PARKING BRAKE is off/released.

2) Depress PARKING BRAKE for 1 second.

3) Release PARKING BRAKE for 1 second.

4) Depress PARKING BRAKE permanently.

If vehicle is already parked and the PARKING BRAKE is already applied:

1) Keep vehicle in Park, PARKING BRAKE should be on.

2) Release PARKING BRAKE for 1 second.

3) Depress PARKING BRAKE for 1 second.

4) Release PARKING BRAKE for 1 second.

5) Depress PARKING BRAKE permanently.

Notes:

The parking brake transition time must be less than 2 seconds between depress

and release.

This procedure must be repeated anytime the unit or vehicle ignition is turned

off.

XDVD3201 OPERATION

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

No comments

Dual XDVD3201 Owner's Manual Page 27